Want to take a shower bath shower installation method to remember

A busy day, back home, open the water heater, wash a hot hot bath, this should be the simplest wish of many people every day now. Therefore, it is necessary to install a comfortable and practical shower room. So how do you install the Shower Head, Shower Valve, Shower Faucet? What are the precautions? Of course, the store owner may send someone to help you install the shower room, but if you understand this, you can better guarantee the installation quality.

Shower installation process:

1, the installation of the bottom basin, the first is to combine the bottom basin parts, to determine the level of the bottom basin, to ensure that there is no water in the basin, the tube to distance with the telescopic distance, and then the net pelvic floor and floor drain connected firmly.

2. Testing and protection: After the installation, it is necessary to test the water to ensure that the water is unobstructed. Finding and punching holes: Use a pencil and a level rule to determine the drilling position of the aluminum material against the wall, and use the impact drill to drill holes.

3. Install the aluminum material: Knock in the rubber particles at the drill hole and lock the aluminum bar to the wall with screws.

4, fixed glass: The glass clamped locked in the hole in the bottom basin, and then fixed with screws.

5. Install the top pipe: Find the corresponding location above the fixed glass drill hole, install (straight/oblique) holder and connect the top pipe. Fix it to the top of the glass with a bender sleeve.

6, security device rack: measuring position installed sanitary ware

7. Install the door: Install the hardware of the door and install the hinge at the reserved hole of the fixed door. After loading, adjust the position of the axis of the lotus leaf until the door feels best.

8, do a good job of waterproofing: In accordance with the requirements of the glass on the side or below the installation of suction or water strips. Seam the aluminum with the wall, the glass and the bottom pot joint seam tightly with silicone.

9. Debugging and tightening: Check whether each part is comfortable and smooth, and find that the problem should be adjusted in time. After adjusting, tighten the corresponding screws to make the shower room more secure.

10. Closing work: The decorative aluminum strip will be stuck in the wall aluminum to ensure its neat appearance. Finally wipe the entire bathroom with a rag.

Shower room decoration experience